Toothbrush Toothpaste Holder 3D print model

This is a comprehensive wall-mounted toothbrush, toothpaste, and comb holder for a bathroom. There is a section on one corner designed for a Philips Sonicare as shown, with a wire-wrap on the side so there are no dangling wires at the sink.

The wall-mount piece has three well-spaced recessed screw-holes, and a part that extends downward for durability of the mounting under downward forces.

The holder conveniently lifts up off of the mount for ease of cleaning the holder in the sink, and then can be set down back over the mount. It should be a snug fit, but able to be removed and placed back for this purpose.

In the photos you might notice it is very shiny, which is because after printing I sprayed it down with rust-oleum high-gloss enamel spray to give it a water-resistant surface which should be much easier to repeatedly clean.