This is a redesign based on the Disneyland Japan Mickey Shaped Soap.

I made this Adaptor to fit on any standard Bath and Bodyworks foaming soap pump dispenser.

How to use: https://www.facebook.com/105267271318523/videos/105274791317771/?t=1

3D PRINTING SETTINGSI recommend printing in on an SLA resin printer, but Just keep in mind that if you print in on a FDM printer, thake shure that is water proof.

Is verry important that you dont change inside mesures, that need to be more simetrical as possible.

Make sure to place supports only were that you can reach and remove or it will not work.Tip, use a curve tool to pull the supports out through the three holes at the bottom.

If you are having problems to take out those supports, try to print the arquives Half - Bottom and Half - Top and join the two parts with glue.

The secret is inside, I printed more than 10 prototips to find the better way to split the foam in the right proportion.One tip, try to use a dense soap to have a denser foam, it´ll be better. Here I´m using 8 parts of liquid soap to 2 parts of wather, but it will depend of the brand of liquid soap.