This RC plane is completely 3D printable with the exception of the parts listed below. It uses a combination of built-in spars and reinforcement into the files, and 2-3% gyroid infill for additional strength. A detailed guide is included and shows the assembly of parts and recommended printing parameters.

It is recommended that you are an intermediate builder have a well-tuned LW PLA, LW PLA-HT, LW ASA, or ASA Aero printing profile for your exact printer. The build guide will show any additional print settings required.

Specifications:

Wingspan: 747mmLength: 780mmFlying Weight (1000mah 3s, Colorfabb LW-ASA): 515gFans: QX Motor 30mm 6000KV(4s)-7000KV(3s) or Xfly X3 type3.7g Servos X2 or X3(fixed landing gear): DSPower 3.7g (or similar)8g Servo: DSpower 8g or similarESCs: 20-30A (cross sectional dimensions < 10 x 20mm)Set Screws (Optional for fixed gear) X2: 2.5-3mm diameterBattery: 1000mah-1200mah 3-4s >/= 30c discharge rate LIPOSpring Steel Wire: 1 and 1.5mmWing Spars: 3mm carbon rod, 625mm total lengthMagnet X2: 10x10x2 or smaller

Build Guide is included in the file download

UPDATES:

5/27/2024: Added several important print settings to the build guide8/24/2025: Added Wing Flex Support part, significantly reducing the amount of flex that the center of the fuselage experiences during positive and negative G loads.9/4/2025: Added mountable wing tip fuel tanks, located in the wing folder