The back plate is an important fastening element in my masks. This design was developed by me about 5 years ago and despite the apparent simplicity, it is a good solution. 4 attachment points (2 straps) is enough for most cosplay projects, but if your mask weighs more than 600-700 grams, I advise you to use an additional 5 attachment point.If you want to be able to adjust the tension of the straps, I suggest using buckles with two slots (also 30mm).Also, pay attention to the width of the rubber band. This back plate is designed for 30mm wide tape.

I can also create a 3D model of a branded back plate for you with your logo. You can see an example in the last 3 pictures. This service will cost you $20. Send me a private message if you need details

I don’t mind if you’re going to sell masks, helmet, etc. made using my models. My big request is to tagging me in Instagram in your posts (@RTprops). Also please do not forget to your feedback, it is very important for me :)

UPD 11 AUG 23:added backplates with EvoFox, CyberCat and EvoWolf logos

UPD 03 MAR 25:Added a 3d model of the buckle. in case you want to print this yourself