Description

• You will receive all individual parts minus the blasters.
• Compared all details while 3D modeling, which results in an accurate proportion (see comparisons 1 and 2)
• Make sure to scale it upon your own thigh measurements. (If scaling is required be cautious that you have to pre-fit it either digitally or a small portion of the pistol to see if it fits inside the holster pistol seater)
• Parts are modeled after the 501st CRL and the necessary details are all included for the requirements.

Thigh V2

• * The holster rectangle hole for the Westar 35 blaster pistols now has more tolerances when inserted into the rectangle hole. 5mm front and back clearance of the holster and 3mm clearance at the side of the holster.

The files has been thoroughly researched and looked at. Some minor details might be a Designer error. I have printed most of the files if not all (if for some reason you've found errors) please point it out and I will update the files LIFE LONG service accordingly to your feedback!

Feel free to message me for support!

Check out my other listings if you wish to purchase parts individually!

**3D Files are meant as personal use and not to be sold as 3d files.

PM me if you wish to vendor finished commissioned pieces or 3d prints!**