The buyer left positive feedback on this model
There's a strange gap in the handle that makes printing awkward. The handle and blade are left as one piece in the stl files, so you either have to cut them yourself or print them upright for the best detail and pray it doesn't fall over. Actually putting the pieces together is also a headache because there's barely any leeway between the mirror piece and the disk holder. The disk holder itself is also super fragile and literally impossible to print as one piece without using supports that are impossible to remove. Also, printing the 92cm rod is almost impossible without some kind of imperfections, and good luck finding a good fitting tube, because if not, the mirror piece is going to clip the inside of the gold piece.
Does the disk spin or is it static once it's put on?
I'm having trouble with the "mirror" piece n thenmiddle of the blade and handle. I was wondering where to put it since it comes on some sort of stand, am I supposed to remove it from that part or keep it in while building it?
Does the file split into pieces?
