I just finished printing this. I was really excited about it because I was hoping to wear it for halloween. Unfortunately it printed just a tad too small for my big head, but that's my own fault for not measuring properly and resizing as needed. I was able to print it in 5 days and 20 hours at a .16 layer height by raising my supporting angle to 65" in Cura and then printing at 60mm/s, along with a few other support tweaks. It almost failed because I didn't put a brim on my supports, but luckily it failed successfully. My two big complaints are this: 1. The eyes are too wide to actually wear the mask. Technically, this is great for accuracy to the mask in the game, but it makes it essentially unusable as an actual mask. I'm looking at cutting out parts of the horn and putting in a tinted visor to see through, but I'm not sure how it'll look. 2. This is the only piece available. Not the designers fault, obviously, they did great making this helmet. I just wish there was more armor available to print as I'd like a whole suit.