These are files to be printed for use in the Phantom 4 / Pro of low-cost GNSS L1 or L1 / L2 receivers such as EMLID M+ / M2 or POLARIS Alpha / Alpha +.The support is fully attached to the drone frame.

The kit contains 6 parts: Bracket, Receiver coupling, battery coupling, cover battery, antena coupling and base for coupling antenna.

Weight Bracket(PLA): 25g / 0,88oz

6 piece weight (PLA): 108 g / 3,8 oz

PS: The support can be used for other purposes as it was built for this purpose, to serve various devices.

For the battery use one or two cells of LiPo 3.7v 1000 mA and a TP4056 Lithium Li-ion 3.7V 4.2V Battery Charger Board DC-DC Step Up Boost Module

For antenna base use aluminum foils below the antenna, between the two printed parts.

Settings: PLA, ABS, PETG