Ready to print joint holder + Screw Top.

Tested using ANYCUBIC MEGA-ZERO 2.0 with 1.75mm filament.

See preview images for print direction.

Approximatly 1 1/2 hours to print both components.

It helps to shave the top of the external thread with a stanley knife to get a nice start to the engagement between the two components.

-CAUTION-Because of print direction - item is quite weak along its shaft. Consider painting/varnish finish product to increase strength. Be sure not to paint the threads as they are quite tight.

Adding extruded designs to the shaft should also increase strength - Engraving may weaken.