1/8
Angled Hanger for 3D Printers Elegoo Mars is designed to help more efficiently drain the resin after print.( This is the Digital File for 3D printing! )
I designed it for Original Mars and this hanger is also compatible/tested with all series of 3D Printers Mars Pro and Mars 3.
• This is my personal design. I spent a lot of time making it maximum compact and effective to use.
• Increased distance from platform to vat (you can use it with a much larger model than the original holder allowed)
• The platform holder is designed so that the build-plate is tilted to one corner, for better outflow of resin.
• The holder is very easy to use, and it reliably holds the platform during the draining of resin residues after 3D printing.
SUPPORTS FOR 3D-PRINTING MODELS
Please note that I DO NOT offer pre-supported 3D models!!!
There is a wide variety of 3D printing technologies and materials available for now.I can give some recommendations on the 3D printing technology I use. But I do not make/sell 3D models with supports ...it just does not make sense, because what is good for one technology is completely unsuitable for another.
So, when purchasing this 3D model, it is assumed that you have experience in 3D printing and know what to do.I do not accept any complaints about this!
IMPORTANT ADVICE
Right after 3D-printing, the build-plate can hold a large amount of resin, so please carefully take the plate off and tilt it for a few seconds to allow most of the resin to drain into the vat.Then place the build-plate on the holder and leave for some time to allow the residual resin to drain out of the printed model and the build-plate.
Recommended Basic Settings for FDM Printers:
Nozzle - 0,4 mmLayer Height - 0,2 mmTemperature - 210 C (or you can adjust what you prefer)Wall Line Count - 2Infill - 20% Tri-Hexagon, Connect Infill LinesSupports - basic settings ...just place the 3D model with the rear part on the platformBuild Plate Adhesion - Raft or Brim
