Hello again guys!This is my Iron Spider Bust design from Avengers Infinity War!This model is made by me.Modelling time 8 Hours!I have tried to make it look like both the old spiderman and the new one.The arms are movable. You can move all joints. There are holes for the arms to be placed at the back of the figure after printing. The arms consist of four main pieces. In addition to these pieces, there are connectors as you can see in the images. Spiderman bust is to be printed as a single piece.The model is divided into several parts. Bust, arms and arm connectors.You need to print them all and put together.If you print them all with 0.1mm (100micron) layer height, you will not need sandpaper or any finishing techniques! :) I suggest, print this model with an air brush. I will share my painted model soon. Share your printings with me please! :)

CREALITY CR-10 PRINT SETTINGS

16 cm Height Iron Spider Bust

0.1mm (100micron) Layer Height %20 infill With support, 65 degrees 60 degrees bed heat 200 degrees nozzle heat PLA Filament

16 Hours Printing time. (The printing time may vary by the type of your printer and the size you want to print your model)

ARMS and Connectors

0.1mm (100micron) Layer Height %80 infill (my suggest)No support60 degrees bed heat 200 degrees nozzle heat PLA Filament

6 Hours Printing time for one arm and connectors.You will print the whole model about 2 days :)

No Need for sandpaper or any finishing techniques if you use 0.1mm layer height. Hope you like guys!

If you have any question about my designs or anything, please don't hesitate to write me a message! You can also send me a message for your bulk purchase to. See you on next projects!