Vegeta Badman action figureThis figure is the same scale of the shf dragon ball figures

In this project i made in full PLA.

For a better result, print these parts in PETG:-Pegs-Skirt-Shoulders

For parts that will articulate, always print the fill of the part above 60%.

Important:Use a hairdryer on the part that will receive the connector, place the hairdryer on the part for a maximum of 1 minute. This will cause the plastic to soften slightly so you can connect a ball joint or a regular connector.

Awesome build video here, creditos to sayan x 9000https://www.facebook.com/reel/1463168148813331/

3D printing settingsPrint in Ender 3 pro, in high qualityPrinted in Ender 3 proBed temperature = 70 degreesPrint quality = 0.12mm