This was a request from one of my supporters, He asked if I could do a design for a wall mounted litter bin like the ones found in the 80's. I have done two versions, one has a lid and the other doesn't.

So after a bit of research I found the rough measurements and produced this design, as this model is quite small in 1/76 scale I had to design it in such a way that made it look realistic but was also strong enough once printed and was able to be printed.

In 1/76 scale this model is only approx 7mm High, 5mm wide and 3.5mm deep. The version with a lid is a couple mm higher and slightly wider.

The litter bin has been designed at OO Scale of 1:76.2for HO print at 87%, 1:87 Scale,for TT gauge print at 63.5% 1/120 Scale,for O UK print at 175%, 1:43.5 Scale,for O International print at 158%. 1:48 Scale.for N gauge print at 51.49%, 1/148 scale. (Caution: I have not printed this model in N gauge, so I can’t guarantee its printability)

The example in the pictures was printed on an AnyCubic Mono 4 Ultra 3D resin printer.I recommend printing these on a 3D resin printer to get the best print definition.As per normal with my designs, there is a balance between accuracy and printability, hopefully not affecting the look of the model too much.

Use this link to join CGTrader and download my designs.

https://www.cgtrader.com/designers/PJD1974?referral_id=3218445