Cell Juniors Action figureThis figure is accurate with the SHF scale.This figure have 3.5 inches(9,5 cm).

In this project i made in full PLA.

For a better result, print these parts in PETG:-Pegs-Skirt-Shoulders

For parts that will articulate, always print the fill of the part above 60%.

Important:Use a hairdryer on the part that will receive the connector, place the hairdryer on the part for a maximum of 1 minute. This will cause the plastic to soften slightly so you can connect a ball joint or a regular connector.

Testing figure videohttps://www.instagram.com/p/DRkodf9CZTB/

3D printing settingsPrint in Ender 3 pro, in high qualityPrinted in Ender 3 proBed temperature = 70 degreesPrint quality = 0.12mm