I designed a replica model of the USP-S Silencer from CS2.The thread is spaced so it fits perfectly on the desired airsoft gun with either 11ccw or 14ccw.
Whats included:
- USP-S Silencer 11 CCW
- USP-S Silencer 14 CCW
- USP-S Silencer Hex Patterned 14 CCW
Instructions:You can use the hole on the right side for a screw and hex nut, to make the silencer not move. But you can also use it without.
What you will need:
- 1x M3 Hex Nut
- 1x M3 Screw 8mm - 10 mm
Just put the Hex Nut in the bottom compartment and screw the screw inside. Thats it!
Recommended print settings:
- 0.2 Layer height
- Brim
- Flip the Model 180 degrees
I also recommend using PET or PETG filament if used outside for better UV-protection.
