POTTERMORE WAND 1 - HARRY POTTER 3D print model
This is my Pottermore Wand design 1. Inspired from Harry Potter!
This model made by me! Modelling time 1 hours! It is high-resolution model. Two part. Made in cinema 4D. NO SUPPORT! JUST PRINT! This wand is two part. You need to glue them after print. If you print 100 micron (0.1mm), you won't need sandpaper! :)
CREALITY CR-10 PRINT SETTINGS
100micron (0.1mm) Layer height %50 infill NO SUPPORT 60 degrees Bed heat 200 degrees Nozzle heat
5 hours print time!
I hope you like guys!
You can follow my Instagram pages! @tolgaaxu @buyucusokagi
If you have any question about my designs or anything, please do not hesitate to write me a message! See you on next projects!