I made this ork because there a no Warhammer-Units with handicaps. So for handicapped players of this game i decided to make an Orkboss.

I know, there could be sooooo much dakka, but i think 2 Machineguns and a small mean green Goblin are a good start.

This modell is a Multipartmodell for easier painting and removing the supports.

No matta how crippled you are, whaaagh needs you.

Hope you enjoy the modell. Think in a few days i will present my make (painted and glued).

Printing details for best results:

Print was tested until everything was fine, easy to paint and easy to remove support. Think i printed that wheelchair 5 times...... -.-*

Print the Wheelchair like on the Cura-picture. This Angle is the best way to prevent from difficult positioned supportstructures.Printed in scaled 60%, 0,2mm Layerheight, Printspeed 40mm/s, Zig-Zag-Support