Intended for 3d print.

Royalty Free Licence version. Can be used for commercial purposes by buyer. Please read CGTrader's General Terms And Conditions.

https://www.cgtrader.com/pages/terms-and-conditions

Cheaper version for strictly non-commercial purposes (i.e for personal use) available here :

https://www.cgtrader.com/3d-print-models/games-toys/toys/fleet-of-the-naglfar-8-ships

This model pack contains 8 different longship hulls, as well as masts, rudders and other vital parts to assemble full miniature ships. See detailed list below. The ship types range from simple barge-type hulls to the mythological vessel Naglfar, its prow festooned with the toenails of dead giants.

The ships are intended for use in 28mm scale tabletop games, either as playable units or as scenery. They can also be used for purely decorative purposes outside of gaming, or even as floatable children's toys. The ships can be resized to suit both larger and smaller scales.

All model parts are prescaled to (roughly) 28mm scale. Some assembly is required. Which model part goes where should be fairly self-explanatory, and you can use the images provided on this page for guidance. Feel free to contact me if you have any questions regarding assembly.

Please note that the hull parts are large, and, depending on your printer size, may require cutting into two pieces before printing. I was able to fit the largest hull (The Naglfar) within a 14cm x 14cm x 14cm print area by placing it diagonally from top left to bottom right corner, but you will probably have difficulties fitting the hulls within areas smaller than that without resizing the hull. Cutting a hull across the middle -using any slicer software- and printing in two parts should be no trouble, but you can contact me if you need help cutting the model.

Detailed model part list

• 1 Dragon Ship on land
• 1 Dragon Ship at sea (bottom of hull flattened, see images for reference)
• 1 Naglfar on land
• 1 Naglfar at sea
• 1 Longship at sea
• 1 Snekkja at sea
• 1 Wide Snekkja at sea

• 1 Wide Longship at sea

• 1 Mast with rolled up sail

• 1 Mast with unfurled sail

• 1 Rope (left and right side within the same .stl)

• 1 Rudder

• 1 Throne (purely optional, intended to be mounted at the back -sorry, aft- of the ship)

• 1 Shield

• 1 Oar

• 1 Swords (Intended to lean on throne or elsewhere on ship. Purely optional. Ornate and plain variant within the same .stl)