Orava Castle – Cliff-Top Fortress with Cave, Stairways & Citadel | D&D Tabletop Terrain | Supportless STLFantasy Cliff Castle on a Sheer Rock – Three-Tier Stronghold for D&D, Pathfinder and Wargaming (FDM-ready STL)Short description

A three-tier fortress on a sheer limestone crag, inspired by Orava Castle in Slovakia, on a 100 mm octagonal base. A gatehouse with a portcullis relief, a middle castle carved into the rock, a citadel on the ridge with a tall watchtower, 53 stone steps in four flights and a hidden cave entrance to the underworld. It prints in one piece on an FDM printer with no supports.

Technical specificationsBase: regular octagon, 100 mm across flats / 108.2 mm across corners, 5 mm thickFootprint: 100 × 100 mmOverall height: 102.2 mm (tip of the lookout tower)Levels: lower castle 10 mm, middle castle 30 mm, citadel ridge 58 mmParts: 1 (single piece, no assembly)Mesh: approx. 64,000 triangles, watertight / manifoldUnits: millimetres (imports at the correct size)Volume: approx. 154 cm³ (solid)Supports: not required (FDM)Scale: a tabletop centrepiece / landmark that pairs with 28–32 mm miniatures. It is not a walk-in building.Recommended print settings

FDM (PLA / PLA+, 0.4 mm nozzle)

Layer height: 0.12–0.16 mm (0.12 mm for the crispest steps and towers)Perimeters: 3Infill: 10–15 %Supports: noneOuter perimeter speed: 25–30 mm/s for the thin towersCooling: 100 %. Above 70 mm enable slow down for small layers (minimum layer time 8–10 s)Brim: not needed (about 80 cm² of flat contact area)Orientation: flat on the base, as suppliedBuild volume: 100 × 100 × 102 mm. On smaller printers scale down to about 75 %.