It is said that when the Dusk Maker appears in the battlefields no one is left to tell the story of the battle. Nor friends nor foes.

A happy yet very deadly being to add to your wargames, rpg campaigns or menacingly guard your shelfs.

The pre-supported version it's meant for an 80mm. base but if you adjust the flames/energy thingui of the base it can fit on smaller or bigger ones without adjusting the size.

Printing parameters:

This models are intended for resin printers and tested with an Elegoo Mars and an Anycubic photon s.

The support are made for 0,03mm layers and the test prints you see in the image were made with this parameters as well as 6-9 seconds of exposure per layer depending on the resin.

I highly recommend to remove the supports after cleaning but before curing for better results. For the parts where the supports won't come out e