Experiment mode enabled!

This fan cover is based on the Zelda Tears of the Kingdom Logo with a few modifications to try and make it printable.

I have experimented on the text outside of the cover, it should work ok if you have sufficient clearance around your fan.

The Fan cover is meant for RGB fans so that the different layers paint the picture for you!

IMPORTANT NOTE

Some of these fan covers cover quite a lot of fan. They are meant for aesthetic purposes mainly, I recommend using a small spacer to allow additional airflow.I have been sticking the covers to the fan screws with sticky pads, this gives a small additional space from the side. I have had no temperature issues.

Printer: Prusa i3 Mk3sLayer Height: 0.2mmInfill: 25%-40% the higher, the better the light will be blocked.Material:Time to print: about 3-4hrs (text is 4mm high)