1/9
I modeled the case for a specific board based on a ready-made case from AliExpress (DC DC 9A 300W 150W Step Up Module Boost Converter Step Down Buck Converter 5-40V to 1.2-35V Power module LED Driver XL4016). The geometry was adapted to the board dimensions, cutouts for the connectors.In this case, I did not use holes for connecting screws, the assembly was planned to be one-time and for my own needs.Perhaps the upper part will not fit tightly, since in the last corrections I reduced the dimensions, but initially everything was planned for gluing the case parts
Important!!! I use a 4S battery in my build of this boost module and set the voltage according to the consumption of my device on a fully charged battery, when connecting 5S batteries the voltage will increase and may damage the device!!!
For assembly I used:-glue for plastic-wire for my own laptop-XT60 connector
