A very practical wallet, small and very easy, print and use.

You just have to remove 3 pieces of support at the end of the printing very simple, that i place myself very carefully, not affecting the print quality nor adding a lot of unnecesary supports, in the GCODE archive i attached. If you want to slice an place the supports yourself i will leave the STLs too.

MATERIALS:

Rubberband 80mm diameter x 2 mm thickness

Easily accommodate up to 6 cards + 1 RFID card ( to block NFC unwanted reading of your cards) and on the secondary holder on the reverse side, for bills or papers that are easily accessible-

In case you want to customize your wallet do not hesitate to write me an email to 3dprintnation@protonmail.com or a message through the site.

The model consists 1 part as shown in the instruction manual attached in the photo.

1 X PIECE ( WALLET + SUPPORTS CUSTOMIZED INSERTED, NO NEED TO USE SLICER)

Drawing dimensions

Width:6.3 cm Length:10,65 cm Height:1.5cm

Ideal quality: 0.2mm

Printing speed: ( The slower the better)

Ideal 20 mm/sNormal 25mm/sTops 30 mm/s

If you need additional information let me know