There is a difficulty in cleaning multiple bearings, as in the case of rollerblades that use 16. That's why I was inspired by an idea from the internet and created this type of pot that lines the bearings and facilitates maintenance and cleaning.

It was tested and printed without great difficulties and without the need for supports, it also presented a good resistance, of course that depends on the filling that each one will put in the slicer. I used 20% and it was enough.

I printed it in standard mode, with 0.2 nozzle, speed 50, temperature 200 and table 60 in PLA.

#gadgets #skate #rollerblade #bearing #bearing cleaner #skateboard accessories