1/23
Six small drawers — more compartments without going to micro size.
WHAT IT ISSix drawers of 64 mm across the front and 40 mm high, for parts that need separating but are too big for the micro grid. The middle ground between the 2 × 2 block and the sixteen-drawer unit.
AT A GLANCEEnclosure: 150 × 150 × 150 mm (W × D × H)Drawers: 6x — 64 × 145 × 40 mm (W × D × H)Module: Medium, 150 mm footprintMagnets: 6 mm disc magnets in the side pockets (optional)Printing: no supports required
INCLUDED• Enclosure, printed in one piece• 6 × drawers, 64 × 145 × 40 mm
BUILT TO COMBINE
Every unit in this range is built on the same two rules: a shared footprint grid, and a shared magnet pattern. Units sit flush with their neighbours and lock there with 6 mm disc magnets seated in the side pockets, so a row stays a row while you pull drawers in and out of it. Drawer blocks, top units, racks and holders all use that same grid, which is what lets a bench grow a unit at a time and still line up.
PRINT NOTES
Files are modelled full size in millimetres and print without supports on a typical FDM machine. Magnets are optional — the pockets can be left empty, in which case units simply stand beside each other instead of locking. Print at 100%: the magnet pockets and the module depend on it, so scaling is not supported.
LICENCE
The files are for personal use only. You may not resell, share or redistribute the digital files, and you may not sell physical prints made from them. Independent design, no affiliation with any other company.
REVIEWS & COMMENTS
accuracy, and usability.

