This is a 3d printable ear hook for the airpods pro 2

I tested it and it works very good. If it doesn't fit you can reshape it, you have to make it warm(preferably with a paint dryer)

Printed with TPU

Best Print settings: Nozzle Temperature:

Temperature Range: 210°C to 230°CRecommended Starting Point: 217°C.

Bed Temperature:

Temperature Range: 40°C to 60°CRecommended Starting Point: 50°C.

Print Speed:

Speed Range: 15 to 30 mm/sRecommended Speed: Start at 20 mm/s.

Layer Height:

Range: 0.1 mm to 0.2 mmRecommended Height: 0.2 mm

Retraction Settings:

Retraction Distance: 1 mm to 2 mm. Retraction Speed: 20 to 30 mm/s.

Recommended Density: 20% to 40%.

Infill Pattern:

Recommended Pattern: Gyroid or Grid.

Fan Speed: 0% to 30%.

Wall Line Count: 3 (or a total thickness of 1.2 mm if using a 0.4 mm nozzle).

Print Bed Adhesion:

Adhesion Type: Skirt

Multiplier: 100% to 105%.

Z-Hop When Retracted: Enable this feature with a height of 0.4 mm to prevent the nozzle from dragging across the print