Severian Lowell's sword from Zenless Zone Zero now in 3D printable form for cosplay / prop etc.!

Length: 140cm / 4ft7in

For main support you'll need 16mm / ⁵/₈ inch diameter pipe (pvc / aluminum / dowel)Length: 81cm / 31,9 in

For tip middle/tip of the sword you'll need 12mm / ¹⁵/₃₂ inch (pvc / aluminum / dowel)Length: 50cm / 19,9 in

If you want to further reinforce the tip of the blade, print Blade_6-with-3mm-metaltip and insert 3mm metal rod approximately length of 15cm / 5,9 in

Sword base uses two (2) 12mm / ⁵/₈ in diameter supports (pvc / aluminum / dowel)Length: 8cm / 3,1 in

Side blades use two (2) 8mm / ⁵/₁₆ in diameter supports (pvc / aluminum / dowel)Length: 15cm / ¹⁹/₃₂ in

Star parts snap to their places with designated holes. Connect with glue when everything else is finished. Finish these parts before gluing though for best result.

Not for physical resale, if you're going to do it anyways at least ask or shame on you!