1/18
This is a digital 3D printable model of the Shakra Mask and Bracelets from Silksong.
Included Files
All cut parts are placed on the print bed just as we would print them, saving you time.
3D Model Dimensions
Printer Settings
Settings may vary depending on your printer, so treat these as a starting point.
Assembly
You will need glue, black wire (max 1.8 mm wide), a stretch band, 4pcs 10×3 mm neodymium magnets, and optionally white pantyhose and padding.
Mask
• There are two versions of Part 01 — with and without the visor. Make sure to choose the one you prefer.• If you're using the version with visor holes, we recommend covering the mask with white pantyhose before inserting the eyes.• Use the included pins and glue the parts together.• Glue the eyes into the holes; you can bend them using hot water or a heat gun, but it’s not necessary.• For the antennas, insert a black wire or filament (max 1.8 mm) and secure it with tape.• Use a stretch band to wear the mask. For comfort, consider adding padding inside.
Note: Pins for the Mask and Bracelet are different!
Bracelet
• For best wearability, use 10×3 mm magnets — this allows the bracelet to open and close easily.• Glue the included pins only to one side of the bracelet.• Insert magnets into both sides. Be careful to match the correct polarity.• Magnets hold the bracelet together, and the pins keep the parts aligned.
No 3D printer? No problem! Search for your local 3D printing services.
This fan-made model was brought to life by 3Demon, a team of modeling and 3D printing enthusiasts based in Prague, Czech Republic. We’ve been creating 3D printable models for over a decade, from cosplay accessories to all sorts of interesting designs.
