Malleus Draconius Scepter from Twisted Wonderland 3D print model

Malleus Draconius Scepter from Twisted Wonderland

Total height: 1.97 cm (Only if you use a 116 cm structural base, use it depending on your height) Sliced in to 37 pieces (just 29 in the zip, the center pieces of the big wheel needs to be printed 6 and 4 times each) The big wheel can rotate

You will need 4 structural tubes:

• The principal is a 32 mm and 116 cm long (If you use a longer one, your prop will be taller)
• The others are tinner: 5mm and 32,5 cm long || 5mm and 18 cm long || And 5 mm and 51,5 cm long

Every piece is less than 25 cm, for an easier print