The model is designed in such a way that it can be put on a zipper without unsewn the ends for the easiest possible installation. Therefore, it consists of several parts.

I printed this with ABS, I think PETG would work just as well. But if you decide to do this with PLA, keep in mind that when heated to 50 degrees Celsius, PLA becomes soft, which will lead to breakage. Direct sunlight can heat it up to more than 50C, just keep that in mind.

Entidades FBX exportadas zipper_slider: 489 faces 1 materiais

Entidades FBX exportadas zipper_slider_hand: 782 faces 1 materiais

Entidades FBX exportadas zipper_slider_hand_classic_v1: 486 faces 1 materiais

Entidades FBX exportadas: 500 faces 1 materiais