3D MODEL DESCRIPTION

Please print the downloaded STL file without changing its orientation, making proper use of tree supports and using appropriately colored filament.(The body.stl file has a relatively small contact area with the build plate, which may cause instability during printing. Therefore, please make sure to enable both Support and Brim in your slicer settings before starting the print.)

Once the print is finished, attach the eyes to the head.

Then attach the head and the cape to the body with a small amount of glue.

Assemble Hornet’s weapon by gluing the two parts together.

Carefully place the weapon in Hornet’s hand so it won’t break.

Secure the completed figure to the base.

Adding a bit of paint will make the model even more appealing.

The model shown in the product thumbnail was printed at 60% of the original scale, resulting in a height of about 10 cm. If printed at 100% scale, the figure will be approximately 17 cm tall.

3D PRINTING SETTINGS

This model has been specifically tested using a FDM Printer with 0.4mm nozzle and PLA filament.The following print settings were used:

Layer Resolution: 0.12mm (high quality) / 0.2mm (standard quality)

Filament: PLA

Printer Type: FDM

Nozzle Size: 0.4mm

The model prints very well with these settings and is recommended for use with PLA filament for optimal results.