If the measurements here are correct the mask is undersized. It should be 54cm tall. I just bought it and it was a mistake. This thing isn’t even close to accurate. The rows of detail on his collar go a couple inches too high up his neck. They’re too tall and his neck is mostly covered. The actual mask has most of his neck showing. The top of the headdress is too flat, the original has more of a rounded top to it. The headdress comes too far down his forehead and is almost touching his eyebrows. The original has at least .25-.375” gap between the headdress and the eyebrows. The angle of the inlay on his beard is too steep. The inlaid section of the mask are raised and they should be flat. This mask has potential but it’s way off.

Is there a NON-Split version of this?

You fixed everything! Can now print everything on a 10"x10"x10" -- and the beard is fixed. You're amazing - thank you.

You are awesome - thank you! Keep the the great work - these are amazing models and very well thought out for printing. Note - found one issue, the beard has an error - the object box around the STL is at least twice as long as the beard - my slicer gives me an error as well.

Looks amazing! You're incredible talented - thank you for making this. Questions -- 1) Just curious on this first question - is this accurate size to Tutankhamun's Mask? Just starting to print -- printed the face first and assuming the mask's thickness is relatively as think as the mask would be, his skull would have been very small. 2) Printing with a Bambu X1C -- which has a 10"x10"x10" print volume -- everything except the top prints in that volume. Is there a possibility that that could be split in two pieces to fit that volume? Either way - wonderful model!! Cheers!