NOT FULLY TESTED YET (only triangular lids mechanism).

Designed with Fusion 360.

Does not require any glue, all the pieces have threads to assemble them.

Tolerances for all joints were considered.

Maybe some supports are requiered.

Triangular lids open when the laser came out

The design was based on diferent images taken from the movie

Some people think that the extreme of Rey's Staff is the new Lightsaber, but is NOT. It's only VERY similar. I've considered that too.

I decided to split the saber in 4 parts in orther to print them with different layer height, if you wish. I recomend to print, at least, 01.Emiter+Lids with 0.1 layer height because of the mechanism