Chibi figure of Moma Kumakura from AITSF / AINI. Comes with a head and body file, which connect at the neck. It is recommended to print the head at an angle and the body upside down.

Personal Recommended Cura Settings:

Walls:

• Wall Thickness: 1.6mm

Infill:

• Infill Density: 5-10% (make the body a higher infill percentage than the head and make sure to increase the density of smaller forms so that they don't break)
• Infill Pattern: Lines

Support:

• Support Placement: Everywhere
• Support Overhang Angle: 60-65 degrees
• Support Density: 15-20%
• Enable Support Interface
• Enable Support Roof
• Enable Support Floor
• Use Towers

Build Plate Adhesion: Raft

Size: Print Head & Body at 72.51% for a ~5in figure

Angle: It is recommended to print these files at an angle where minimum support is required, while being enough to prevent the print from failing. I tend to print the heads at a 30-45 degree angle and the bodies at a 180 degree angle (so that the feet are in the air).

Copyright: This is PERSONAL USE only. You cannot sell the file or print and sell the figures.