Only the armor and the staff weapon included. The helmet is under construction and will follow soon as a seperate model.

Jaffa armor: It is only the breastplate with shoulder protection. The helmet is not included.

My interpretation of a Goa Úldt / Jaffa armor. I need it for the German carnival and cosplay.

Need a printer with 350 X 350 mm build space in the base. The height should be at least 250 mm to print the shoulder parts upright.

I connected the parts with screws and some cable ties. The straps over the shoulders were printed by me from TPU. If that is not technically possible, you can also use cable ties or leather strips et cetera there.

Jaffa staff weapon

Total length 1.83 meters

A Jaffa staff , based on the movie Stargate. The photos were all taken after the 1st painting. After the 2nd paint the surface will look 100% good. Need a hard, straight broomstick as a core with a maximum diameter of 21 mm. 2 Blue LED, 5 mm diameter, 3 volts operating voltage. A battery compartment for 2 X AA battery and 3 volts. Ideally with built-in switch. Printable on a FDM printer with 350 X 350 X 400 mm build space. Approximately 2 KG of PLA or PETG filament is required. A soldering iron is mandatory, a soldering station would be better.

Several M 4 screws and a piece of Velcro to hold the battery box are also required.

The printing itself is time consuming, but not very difficult. Nothing for beginners, but also not a professional task.

The model includes the staff weapon and the Jaffa armor. The Anubis helmet will be posted separately in the next few days.

Translated with www.DeepL.com/Translator (free version)