CyberBase Systems Decepticons Underwater Base Elevator Part 2 3D print model

And now we build upwards from the earlier underwater elevator ( https://www.patreon.com/posts/62145746 ) towards the shaft and exit hatch where the Decepticons launch their sorties out from!

Though core class sized, this build can very quickly take up quite a lot of vertical space. The simplified version (as seen above) is almost 70cm tall!

The main sections are the top hatch which features the exit hatch (on the left) and the elevator shaft (on the right)

The hatch door at the very top, being hinged to the door frame via a pin, can swivel out from its closed position, to become a horizontal launchpad to launch or allow Decepticons to return after missions!

=== ASSEMBLY === Though pretty large, the parts involved in this build are fairly simple.

You can stack as many pieces of the TowerShaft_Mid sections to make your own build as tall as you like.

Also, to be even more accurate to the animation, the TowerUpper portions can be doubled up too.

===

Well then, hope y'all have fun 3d printing and assembling this massive piece! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog