Dog Leash or Collar Holder - You want to keep your best friend leash or collar in a nice and friendly holder?

Take a look at this desing, simple to install with a hole to slide the head of the screw in, with 3 steps you will have it in your wall in no time.

Print the hanger in the color you prefer, it take 1 hour and 30 mins to print one.

Make a hole in the wall for a M5 Screw

Slide the head of the screw inside the dog body and voilá, you have you hanger ready.

For this you will need;

DrillM5 Wall Drill Bit1 M5 x 20mm ScrewIt took me about 5 minutes to drill and present the hanger.

The total dimension of the hanger is 6cm and the tail is 3 cm tall, enough to put any leash, collar or keys.

0.2 mm40 mm/sFilament: PLAInfill: 10 %ETA : 1 hs and 30 mins (40mm/s)Depending on printer config

If you have any question just let me know, you can send me an email at 3dprintnation@protonmail.com