Turning Table 3D print model

Turning Table, for photogrammetry.

The model is assembled from 4 parts, 5 part of the washer is optional and not required, the gaps during plastic shrinkage are designed for the average print quality, the thickness of the line is 0.2 mm, filling at will, filling must be taken into account in parts subjected to large loads (bearing sleeve, table fasteners - Filling 90-100%). The model is broken into parts, also aligned and set to print position, in format - STL. Collected and divided into parts model in Blender format. In other formats, the collected model without smoothing modifiers.

You can assemble the model in two versions - 1) With a gap between the table and the base, the gap can be fixed using the washer, minus the fact that the bearing 6201 only center the table, but the back of the vertical is, and the table will be stagged, and the gap will not be saved. 2) The option without a gap, as the table and thought, the table and the base will be rubbed about each other when turning, convenient for fixing the rotation by divisions so that the parts are tightly lightened to tighten the bearing tightly the base in the middle, the optimal option.

For assembly, additional materials are required, Bearing 6201, four bolts and four nuts M5 (bolts are not shorter ~ 25mm)

3D model is ready for 3d print.

Real scale (Collected) - Units: cm ~ 20 x 20 x 2,6 cm.

Formats:

• .blend (Mesh + material (Principled BSDF) no textures ) - Blender (ver. 2.93.1).
• .stl (only mesh without materials). - exported from Blender.
• .FBX (only mesh without materials) - exported from Blender.
• .obj (Triangulated, only mesh without materials) - exported from Blender.
• .glb (only mesh without materials) - exported from Blender.

Rendered in Blender Cycles.