Bicycle smart phone holder 3D print model

Bicycle smartphone holder. For a smartphone with a width of 65-100mm. Allows you to insert photos 64x43mm. All dimensions were for the steering pipe with a diameter of 38 mm., But should also be suitable for not much smaller / larger diameters. The model is designed for 3D printer. To assemble the holder you will need:

• 2 pcs rods with a diameter of 4 mm, length 55 mm,

• 1 pcs Screw with a diameter of 5 mm and a length of 80 mm,

• 1pcs bolt M5x16mm,

• 4 pcs bolts M5x25mm,

• 5pcs nuts m5,

• 2 pcs springs from automatic handles,

• org glass 64x43mm 2pcs.

may be needed:

• 4.5mm drill

• 5.5 mm drill.

Assembly process: 1. It is necessary to fuse the 55 mm rods into the movable part of the holder. 2. Screw the screw in and out (not completely) into the central hole as many times until smooth. 3. To unscrew a screw and to twirl in a flywheel, to heat a screw and to fuse in a wheel. Then seal with a plug (For greater strength, you can cut the slot in the screw head to better stick). All the model is ready, you can mount it.