Transformers G1 Cybertronian Wheeljack 3D print model

Just done up the final paintwork and test 3d printing of all part of Wheeljack, so he's all ready to roll out!

Top and bottom parts have been separated into 4 and 3 pieces respectively to allow for easier 3d printing, especially on smaller printers. The top pieces are also split to make painting easier.

The bottom parts have small peg holes, allowing you to use ~1.5mm rods to align them before they are glued down in place.

The windscreen and 2 side windows are also their own pieces which can be 3d printed in translucent/natural filament. What is shown in our images above show these parts spray painted with clear blue paint to give the cartoon accurate tint. This will also allow for ligtning lighting to be added.

Inside this model, you can print and place the console and seats (as were seen in the original cartoons) or remove them if you want to load up a fellow small autobot car in alt mode. A removable tailgate will close up Wheeljack's alt mode rear.

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http:/www.FunbieStudios.com)

Support us on Patreon - https://www.patreon.com/FunbieStudios