Spider Backpack for Transformers 3D print model

Having done up the articulated arms from earlier, it felt like they had more uses in them. So in line with the spooky halloween season, here's a techno-organic looking spider backpack to equip your Transformers with!

For this piece, the legs simply connect to the main backpack using a single socket piece. So this should give a lot of articulation possibilities for this piece! There are also two 5mm ports on the front and back too, so other accessories can be attached, or a longer tail piece can be created for it too.

The underside of the backpack piece features a 5mm peg which is offset to one side, allowing it to be pegged either higher or lower on a bot's back, depending on the location of the port on its back.

And of course, Wheeljack is more than excited to make use of the extra limbs too. Must be handy for experiments!

The versions of the pack featured above all make use of the shorter limb parts. However, the set of longer limb bits are also included so have fun mixing and matching them up to whatever suits you too!

As always, hope y'all have fun 3d printing this out for your bots! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios