Sword for Transformers WFC Kingdom Dinobot 3D print model

Presenting a new sword for WFC Kingdom Dinobot, which admittedly, is more of a replacement piece to make it a little more accurate (read: sharper) to the animation!

With a tab sized to fit into the port in Dinobot's palm, this piece handles like a charm!

Here's a quick side-by-side comparison of the original piece with this new blade. Had tried to base paint the blade sliver and then go over with a more translucent purple paint coat, but it came out rather opaque. :P

Coming over to its storage in alt mode, the sword still tabs into the base of the tailpiece just fine. But due to its slightly larger geometry, the tail may not close fully. It does give a feeling of tail spines running down the edge though?

Hope this would be a fine addition to your own WFC Kingdom Dinobot too! Would love to see shots of it in action! ;)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog