And here's another accessory from the days of yore which typically disappears too. Doesn't help that it's a fire-able missile either!
And so, here's a printable replacement for Inferno's missile leg!
Designed against the original piece was imperative for the length and fit required for both its uses. Here, it's loaded into Inferno's gun as a missile.
The notches on the back of the missiles were also recreated to be as close as possible and if printed right, will be able to be loaded, caught in place and fired off!
For Inferno's bot mode, this piece can also be stored snugly in front of his shin. And mostly when it comes to his ant mode, having a replacement crucially helps to keep him level and balanced!
==
Just a small note about 3d printing this single piece - it would be advisable to print it horizontally so that it doesn't inadvertently snap when loaded as a missile or pegged into his foot.
==
Hope this comes in handy for your own Infernos if they are missing this part. Happy 3d printing! =)
===
This model is not to be uploaded or sold in any form and is intended for personal use only.
Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)
Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog