Midsection and Tower Fillers for Transformers WFC Kingdom Ark 3D print model

Rounding things up in terms for filler pieces for the WFC Ark, here's the bits to fill in the midsection and the hollow rear of the tower!

To make removal easier after installation, there is a tiny little notch on the underside of the protruding feature. This allows for a fingernail to catch on and pull the piece out for transformation.

A 5mm port has been designed into the centre of the piece so that can be used for any accessory or effect part of your choice, or can also allow the earlier mini turrets ( from this set - https://www.patreon.com/posts/53440945 ) to be emplaced.

As a fun little bonus, we have also included a cut-through boarding chute segment where nano figures can be placed for display. This also just pegs onto the same 5mm port as before.

The filler for the rear of the tower is a simpler piece which can be installed in place and just left there for good as it does not impede any transformation.

When the Ark needs to take on its bot mode, these pieces can all be stowed away conveniently into the hollow compartment where the tower rotates to be kept.

There's so much space in there that one thinks more accessories should be created for this big boy :)

In any case, hope that this set, together with the earlier ones, helps to upgrade your Ark to look more complete too. Happy 3d printing! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog