LockOn Missile Launchers for Metroplex Super Mode 3D print model

Designed as a weapons booster set to the Aerialbots team, here's the LockOn Missile Launcher Set!

Comes in a pair of launcher module paired with a lower assembly laser target trackers.

The parts can be clipped together as a singular unit and mounted underwing on any of the Aerialbots limb bot for air-to-air mode, or sited on the ground for other bots to take out the Seekers. There is a back slot which should sit a prime master or titan master nicely as the weapon operator too!

If you prefer, the two halves can also be separated for any number of mix and match modes. As always, all pegs are sized to allow for siege blast effects to be added for more play and display fun!

But, that's not all - this set is more than meets the eye!

As a homage to a somewhat obscure Super Strong Metroplex mode which were indicated in the original G1 instructions - this set will allows Aerialbot limb bot to be connected onto a Generations Metroplex!

The upper launchers doubles up as the leg connectors. Just slot your limb bot of choice into the connector and then peg the handle from behind into Metroplex's knee shield.

The lower launcher assembly doubles up as the shoulder connectors. Fully extend the towers portion in Metroplex's shoulder, peg the 5mm post in and then lower the tower to lock things in place for a tighter fit. The limb bot can then be slid down snuggly into place!

And there you have it! Super Strong Metroplex, powered up by the Aerialbots and ready for battle!

The parts have been designed so that they should hold nicely even if you choose to put Metroplex into action poses, without having the limb bots fall off!

Hope this little re-imagined blast from the past brings the same smile to your face as it did for us! Let us know if you make other combinations with the other Combiner Wars limb bots too - would love to see how those look!

As always have fun 3d printing till all are one! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http:/www.FunbieStudios.com)

Support us on Patreon - https://www.patreon.com/FunbieStudios