G1 Flamethrower for Transformers WFC Siege Seekers 3D print model

This started off as a request for one of the very first skirmishes we see in the pilot episode of the 84' Transformers! Intercepting Wheeljack and Bumblebee on their return journey after scavenging for some energon, one of the Seekers (hotlink?) used a flamethrower to shoot a ring of flames around our stalwart Autobots!

These weapons sport siege effect compatible barrels and connect to the rear pack using 5mm rubber tubings.

And why stop at a single barrel when you can get the seekers to dual wield these bad boys. As an alternative mode, these blasters can be mounted on the backpack itself with in the barrels in a over-the-shoulders configuration.

Another way to use these are in a dual-barrelled blaster mode, then just add the siege effects of your choice to complete the look!

And of course, these need to go somewhere in jet mode too, so some of the photos also show how they can be pegged on (shown with WFC Seeker Jet Addon - https://www.patreon.com/posts/38603651). The three ports on the rear substitute the original boosters so effect parts can be added here (and the weapon barrels too) to complete the look!

===

The modularity of this set probably allows for many other configurations to be done - so hope everyone has fun 3d printing them out and trying different fanmodes for them! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios