Forearm Missile Pod and Antennae for Transformers Siege Jetfire 3D print model

So here's a couple more piece to help complete Siege Jetfire's getup. The earlier set of addons can be found here - https://www.patreon.com/posts/41714324

This is a fairly straightforward set to print, comprising of a set of missile pods which come in two parts and a small antennae piece which clips onto Jetfire's head from behind. The pods attach to the forearms by pegged onto the rectangular protrusion, and can alternatively have the front missile bits removed to reveal a 5mm port for attaching other effect parts or accessories:

Switching over to jet mode, these pods attach to the underside using the round ports, and should sit just above the height of the landing gear and so does not obstruct Jetfire's ability to roll out (heh heh)...

In jet mode, the antennae can also be clipped to the underside of the cockpit, or simply stored elsewhere separately.

===

So there you have it, a couple more pieces to make the setup for Jetfire that bit more complete. Hope y'all have fun 3d printing these out to jazz up your own Jetfires too! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios