Fillers for Transformers WFC Kingdom Dinobot 3D print model

Another sore point about the recent WFC version of Dinobot is again the hollow bits in the arms. Well then, time to sort those out!

Here's the set of 4 pieces of fillers each for both of Dinobot's arms. Gave it a little bit of stripey grains in an attempt to match his skin texture.

With these pieces in place, Dinobot would definitely be filling more complete and ready to fulfil his code of being a hero!

Depending on your tastes, you may like to paint the bits to give it a brown which is closer to Dinobot's original skin color. Perhaps a paint wash too, to also give it some depth :)

Happy 3d printing these for your own figure =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog