Exhaust Missile for Transformers Legacy Sideburn 3D print model

After doing up the drag knife for Sideburn, it felt apt to complete his getup with an homage exhaust missile like his original version!

Though obviously non-firing this time around, the missile is meant to fit snugly into the 5mm port on the back of this rear car part to simulate the launcher. From there, it’s actually kinda fun to pose him with the now complete-looking launcher!

Definitely has a very sniper feel to it and less strange than just holding onto a what looks like an unloaded crossbow :P

Coming over to his alt mode, the missile can be attached and used in conjunction with his gun attached onto the roof! Makes him look like he is ready to smoke some Decepticreeps! Or as its name suggests, this can also be attached as a strange hanging out exhaust piece.

Or if you would like to safekeep this and not lose it, it should fit safely inside his vehicle mode under the roof.

And there, hope y’all will enjoy adding this to your own Legacy Sideburns too. Happy 3d printing! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog