Energy Cage for Transformers Legacy Gears 3D print model

Having been scanned by Megatron and found to possess a special personality circuit in his chest, Gears got sadly captured and tossed into this Energy cage!

Designed in a modular fashion, this should fit Gears nicely inside and keep him locked in before Megatron extracts his personality chip!

=== Assembly ===This cage model is basically assembled using just three simple parts, as seen in the attached diagram.

The spheres on the “Cage-Edge” are to be slid onto and affixed onto the middle part of the “Cage-Bar”, which can then be connected at their ends into a cube configuration using the “Cage-Corner”

Depending on the sizing you prefer, the “Cage-Bar” can also be scaled up or down in its horizontal dimension in your slicer of choice before they are 3d printed.

===

Enjoy re-creating and putting together this evil little energy prison for Gears with this set! Happy 3d printing! =)

===

This model is not to be uploaded or sold in any form and is intended for personal use only.

Check out more of what we are up to over at our Facebook Page (http://www.facebook.com/FunbieStudios) or website (http://www.FunbieStudios.com/)

Support us on Patreon - https://www.patreon.com/FunbieStudios | Full listing of Models - https://funbiestudios.com/model-catalog